Filter
Top Products
Ribbons and Cards 9
6. Place the take-up end of the ribbon roll in between the two
black Ribbon Drive Hubs located on the left-hand side of
the printerÕs interior. Load the ribbon take-up end of the
ribbon just as you loaded the ribbon supply end. When
loaded properly, the ribbon should feed underneath both
ends of the ribbon roll.
7. Grasp the Release Tab and gently lower the Printhead
Assembly to close it. Lift slightly on the Release Tab to
latch the assembly shut. Close the printerÕs Top Cover.
When you start to print, the Ribbon Drive Hubs will
automatically engage the notches on both cores of the
ribbon roll.
IMPORTANT!
Do not reverse the ribbon. Damage may occur to the
thermal printhead!
Supply Roll
Take-Up Roll
Cleaning Roller Assembly
Supply Ribbon
Drive Hubs
Take-up Ribbon
Drive Hubs
Ribbon Sensor
Quatro/510323 v3 1/8/99 10:48 AM Page 9