Filter
Top Products
Notices
The information in this document is subject to change without notice.
NO WARRANTIES OF ANYKIND ARE MADE WITH REGARD TO THIS MATERIAL, INCLUDING,
BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITYAND FITNESS FOR
APARTICULAR PURPOSE.
The manufacturer shall not be liable for errors contained herein or for incidental damages in
connection with the furnishing, performance, or use of this material.
This document contains proprietary information which is protected by copyright. All rights are
reserved. No part of this document may be photocopied, reproduced, or translated into another
language without the prior written consent of the printer manufacturer.
Patent Pending
Trademark Acknowledgments
Windows and Microsoft are registered trademarks of Microsoft Corporation. All other trademarks are
the property of their respective owners.
Printing History
Edition 1.3, #981231
© Copyright 1997
All rights reserved.
For Users in the United States:
This equipment has been tested and found to comply with the limits for a Class Adigital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
¥ Re-orient or relocate the receiving antenna.
¥ Increase the separation between the equipment and receiver.
¥ Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
¥ Consult the dealer or an experienced radio/TV technician for help.
¥ Use of a shielded cable is required to comply with the Class Alimits of Part 15 of the FCC Rules.
¥ You are cautioned that any changes or modifications not expressly approved in this manual could
void your authority to operate and/or obtain warranty service for this equipment.
For Users in Canada:
This digital apparatus does not exceed the Class Alimits for radio noise for digital apparatus set out on
the Radio Interference Regulations of the Canadian Department of Communications.
Le present appareil numerique nÕemet pas de bruits radioelectriques depassant les limites applicables
aux appareils numeriques de la class Aprescrites dans le Reglement sur le brouillage radioelectrique
edicte par le ministere des Communications du Canada.
CAUTION!
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT TO RAIN OR
MOISTURE. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
EXTERIOR PANELS. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL. OPERATE THE UNIT ONLY ON 110-120 VAC, 50/60
Hz. FOR PRINTERS THAT HAVE BEEN SHIPPED OUTSIDE OF THE UNITED STATES
AND CANADA, OPERATE THE UNIT ONLY ON 220-240 VAC, 50/60 Hz. USE PRINTER
ONLY WITH THE INCLUDED POWER SUPPLY.
ii
Quatro/510323 v3 1/8/99 10:48 AM Page ii