Filter
Top Products
FS-8700-17 Optomux Driver Manual
FieldServer Technologies 1991 Tarob Court, Milpitas, California 95035 (408) 262-2299 fax: (408) 262-9042
Visit our website: www.fieldserver.com E-mail: support@fieldserver.com
Page 23
Read/
Write/
Both
COMMAND NAME OPTO22_FORMAT
OPTION
MASTER LENGTH
CONSIDERED (See
Notes)
NOTES
r
READ AND AVERAGE INPUT 4
Only one module position may be
specified. This position is averaged
and the result is put in the first
element of the data array The number
of samples is specified in modifier1 in
the csv file.
w
START INPUT AVERAGING 3
Only specified module positions get
affected by command. First element
in data array is sent as the number of
sample to average over.
r
READ AVERAGE COMPLETE BITS 1 2
If format=Bit then length is considered
during storage as bits are unpacked
into data array. If format is non equal
to bit then result is written as a single
value into one array element.
Retrieved data is stored in standard
data array.
r
READ INPUT AVERAGE DATA 3
Only specified module positions get
read. Data read gets put in
corresponding positions of data array.
r
READ TEMPERATURE INPUTS 3
Only specified module positions get
read. Data read gets put in
corresponding positions of data array.
r
READ AVERAGE TEMPERATURE INPUTS 3
Only specified module positions get
read. Data read gets put in
corresponding positions of data array.
w
SET INPUT RANGE 3
Only specified module positions have
their range set to the 2 values found
in the data array. 1st is high limit,
second is lo limit.
r
READ OUT-OF-RANGE LATCHES 4
High limit latches are placed in first
element of data array. Low limit
latches are placed in 2nd element of
data array.
b
READ AND CLEAR RANGE LATCHES 3
Only specified module positions get
read and cleared. Data read gets put
in corresponding positions of data
array.
w
CLEAR OUT-OF-RANGE LATCHES 4
r
READ LOWEST VALUES 3
Only specified module positions get
read. Data read gets put in
corresponding positions of data array.
w
CLEAR LOWEST VALUES 3
Only module positions specified get
affected by command.
b
READ AND CLEAR LOWEST VALUES 3
Only specified module positions get
read and cleared. Data read gets put
in corresponding positions of data
array.
r
READ PEAK VALUES 3
Only specified module positions get
read. Data read gets put in
corresponding positions of data array.
w
CLEAR PEAK VALUES 3
Only module positions specified get