Filter
Top Products
FS-8700-17 Optomux Driver Manual
FieldServer Technologies 1991 Tarob Court, Milpitas, California 95035 (408) 262-2299 fax: (408) 262-9042
Visit our website: www.fieldserver.com E-mail: support@fieldserver.com
Page 24
Read/
Write/
Both
COMMAND NAME OPTO22_FORMAT
OPTION
MASTER LENGTH
CONSIDERED (See
Notes)
NOTES
affected by command.
b
READ AND CLEAR PEAK 3
Only specified module positions get
read and cleared. Data read gets put
in corresponding positions of data
array.
r
CALCULATE OFFSETS 1
Only specified module positions get
calculated and read. Data read gets
put in corresponding positions of data
array.
w
SET OFFSETS 1
Only specified module positions get
written. Data written gets extracted
from corresponding positions of data
array.
r
CALCULATE AND SET OFFSETS 1
Only specified module positions get
calculated and read. Data read gets
put in corresponding positions of data
array.
r
CALCULATE GAIN COEFFICIENTS 1
Only specified module positions get
calculated and read. Data read gets
put in corresponding positions of data
array.
w
SET GAIN COEFFICIENTS 1
Only specified module positions get
written. Data written gets extracted
from corresponding positions of data
array.
r
CALCULATE AND SET GAIN 1
Only specified module positions get
calculated and read. Data read gets
put in corresponding positions of data
array.
w
SET OUTPUT WAVEFORM R 4
Uses opto22_modifier1/2 from the
CSV file set waveform rates and
types. Only specified positions get
affected. 2 elements of data array
are used.
w
IMPROVED OUTPUT WAVEFORMS 4
Uses opto22_modifier1/2 from the
CSV file set waveform rates and
types. Only specified positions get
affected. 3 elements of data array
are used.
Notes on how the Length parameter is used in the CSV file.
1. The length parameter is always considered.
2. The length parameter is only considered when the keyword Bit is used in the
opto22_format parameter.
3. The length is only used using the address/length method to specify module
positions or when the dynamic method is used to specify module positions.
4. The length is never considered.