Filter
Top Products
+
++
+
80,',7<
80,',7<80,',7<
80,',7<
90%, non-condensing
3
33
3527(&7,21
527(&7,21527(&7,21
527(&7,21
The power supply is protected against Open Circuits, Short Circuits, Overloads and Arcs
$
$$
$*(1&<$
*(1&<$*(1&<$
*(1&<$33529$/6
33529$/633529$/6
33529$/6
500A/102A/152A are approved to UL2601 and TUV 601-1. Class I, per IEC 601-1. 202A
pending approvals.
7
77
75$16,(17/
5$16,(17/5$16,(17/
5$16,(17/,1(3
,1(3,1(3
,1(3527(&7,21
527(&7,21527(&7,21
527(&7,21
Meets requirements of IEC 801-4, 801-5
(6'
(6'(6'
(6'
All Remote Control Functions meet requirements of IEC 801-2
1
11
127()253)&81,76
27()253)&81,7627()253)&81,76
27()253)&81,76
When High Voltage is enabled by using either the "HV Enable" Line or deactivation of the
"Inhibit" Line the power supply will reach normal operation mode (and therefore all other
published specifications) within 50 ms.
$
$$
$&&(6625,(6
&&(6625,(6&&(6625,(6
&&(6625,(6
y Detachable 8 feet (2.4 meters) HV Cable (see Table 2.1)
y 15 pin 'D' plug mating control connector
y Operating Manual
2
22
237,216
37,21637,216
37,216
2.23.1 SUFFIX -SYS
Parallel Operation
2.23.2 SUFFIX -RFI
Optional external fit on filter which reduces conducted Electro-Magnetic Emissions.
Approved VDE0871/6.78 Class B.
2.23.3 SUFFIX -LH
"Low Inhibit" - A +10 to 15 volt (high) signal will allow power supply operation. A 0 to
+1.5 volt (low) signal will inhibit the supply.
83-493-001 Revision G
2 - 3 Specifications