Filter
Top Products
68 Operating Manual BX900 S1
Installation and operation
© cognitas. Gesellschft für Technik-Dokumentation mbH 2010 Pfad: C:\Programme\FCT\tim_app\tim_local\work\WALTER\OBJ_DOKU-4950-006.fm
5.2 Switching the system unit on/off
V CAUTION!
● Before switching the system unit on using the On/Off button, the
PRIMERGY BX900 S1 system unit must be connected to the power
supply for at least a minute.
● If you switch on the system unit and the connected monitor only
shows flickering stripes, switch it back off immediately (see chapter
"Troubleshooting and tips" on page 77).
● The On/Off button does not disconnect the device from the mains. To
fully disconnect it from the mains, you must unplug the plugs from the
sockets.
● Turn the server on when the temperature is in its operating
environment range (10–35°C). For details on the operating
environment, refer to "Safety Precautions". When operating the
device outside of this operating environment, the server may operate
improperly, damage data etc. Furthermore, Fujitsu cannot be held
responsible for any related damage, malfunction, or loss of data, etc.
● Be sure to wait for 10 seconds or more after shutdown before turning
the server on.
● After connecting power cable, press the On/Off button after it passes
for more than 10 seconds.
Switching on the system unit
Ê Press the On/Off button on the system unit (position 4 in figure 14 on
page 60) for 2 seconds. Depending on the BIOS setting, the individual
server blades will also be switched on. This is done in sequence according
to the numbering of the server blade slots (see figure 19 on page 83.)
Ê If necessary, switch on the required server blades
The system unit is switched on and the activated server blades perform a
system test and boot the operating system.
Switching off the system unit
The system unit is up and running (server blades are also switched on).