Filter
Top Products
B.4 Cable Connector
This section describes the connector type and the correspondence between the UPC interface and the signal cable
pins.
Connector type
D-SUB9 male connector (receptacle: female)
Pin assignment
The figure below shows the UPC interface and pin assignment of the signal cable.
Unused pins (pins 1, 2, 3, 4, and 8 in the FIGURE B.2 Connection of the main unit and CVCF) must not be used.
The pin assignment on the cable side is as shown below.
FIGURE B.3 Correspondence between UPC interface and signal cable pins
PRIMEQUEST 1000 Series Hardware Installation Manual
APPENDIX B UPC Interface
86 C122-H004-07EN