Fujitsu FI-6000NS Scanner User Manual


 
Network Scanner fi-6000NS Getting Started 7
5. Select whether "Daylight Savings Time" should
be on or off.
This option is not shown for timezones where
daylight savings time is not used.
6. Press the [OK] button.
The Region/Timezone is set.
Continue with IP address/DHCP settings.
3.5 Setting the IP Address/DHCP
An IP address must be set in order to connect the
scanner to a network.
1. Select the [Network Settings] tab on the top
menu.
2. Select the [IP Address] tab on the left side
menu.
The IP address/DHCP screen appears.
3. Set the scanner's IP address. This may be
done automatically, by pressing the DHCP [On]
button.
The IP address may also be set manually, by
pressing the DHCP [Off] button and entering
the following numerical addresses:
IP Address
Subnet Mask
Default gateway
4. Press the [OK] button.
The information entered is set.
Continue with the DNS settings.
ATTENTION
Do not use an IP address that already
exists in the network.
IP address duplication will cause an
error during setup.
HINT
If the IP address is the same as one
already in use, network communication
problems will occur. In this case, try the
following steps:
1. Disconnect the LAN cable and turn the
scanner off.
2. Reboot the scanner with the LAN cable
still disconnected, and enter a non-
duplicate IP address.
3. Re-connect the LAN cable to the scanner.
When DHCP is set to "On", the following
settings are assigned by the DHCP:
IP Address
Subnet Mask
Default Gateway
DNS Server
WINS Server
Even if DNS or WINS server is set, priority
is given to the scanner settings over the
DHCP settings.