Filter
Top Products
Network Scanner fi-6000NS Getting Started 15
Appendix C Replacing Consumable Parts
■ Replacement Part No. and
Standard Replacement Cycles
The usage count of consumable parts can be checked in
administrator mode on the "Usage Status" screen.
When parts need to be replaced soon, the "Status"
information field becomes orange. When parts need to
be replaced immediately, the "Status" information field
becomes red.
The following table specifies the replacement part
numbers and the standard replacement cycles.
To obtain these parts, contact your FUJITSU dealer or
an authorized FUJITSU scanner service provider.
These replacement cycles are rough guidelines when
using 64 g/m
2
(17 lb) A4/Letter woodfree or wood
containing paper. They may vary according to the type
of documents scanned, scanner usage, and cleaning
frequency.
The following diagram shows the locations of the
consumable parts in the scanner. For more details, refer
to "5.5 Replacing Parts" in the "Network Scanner
fi-6000NS Operator's Guide".
■ Pad Assembly (PAD ASSY)
■ Pick Roller
The glass scanner windows
inside the ADF can become hot
when the scanner is used.
Before cleaning inside the
scanner or replacing any parts,
turn off the power, unplug the AC
adapter from the outlet, and wait
for at least 15 minutes.
Part name Replacement cycle
Pad Assembly
(PA03289-0111)
After every 50,000 sheets scanned or
once a year
Pick Roller
(PA03289-0001)
After every 100,000 sheets scanned
or once a year
ATTENTION
Use only the PFU LIMITED parts
specified. Do not use consumable parts
made by other manufacturers.
Pick Roller
Pick Roller's Shaft