Filter
Top Products
space
commands are used in the following modes:
.
15line
feed mode
A maximum of 15 lines can be fed.
WIF6 to
WIF8
are ignored.
. 63-line feed mode
A maximum of 63 lines can be fed.
WIF7, WIF6, and WIF4 to
WIFl
indicate
the number of lines fed.
WIF8 is ignored.
One of these modes can be selected at the operator panel. For the
selection method,
refer to Operator’s Guide.
When the printer receives a Space command, the printer feeds forms the
specified number of lines after printing all characters in the PDB. If
the Space command is received before the
132nd
(or
136th:I
character code,
the remaining characters are treated as spaces.
If the Space command is
received without character codes,. the printer does not print, it only
feeds forms.
WIF5 must be 1 because WIFS indicates Space commands.
If a Space command attemps to feed forms past the TOF position, the forms
feed can be stopped at the TOF position. This feature is called the
"step-count truncate".
This feature can also be set up at the operator
panel.
For the setting method,
refer to Operator’s
Guidl.
4
-
22
B02P-1500-OOOlA...05