Fujitsu M304X Printer User Manual


 
Example of control sequence data
90 2.3
Ll;l;Z;L10;3;L22;12;T66
9C
1
L
Parameter sequence
X130'
-0
X'37'
-1
X131'
-1
X'38'
-8
X132'
-2
X' 39'
-9
X133'
-
3
X'3B'
-;
X134'---
4
X'4C
-L
X'35'
-5
X'52'
-R
X'36'-
6
X'54'
-T
Codes used in the parameter
sequence
Ll
(4C
31) in the parameter sequence above indicates line
1.
";1;2"
(3B
31 3B 32) indicates channels 1 and 2. That is, channels 1 and 2 are
specified on the first line at the top of the form.
";n
in the parameter
sequence above is used to separate the contents of parameters. As a
result,
the parameter sequence above specifies channels
1
and 2 on line 1.
channel 3 on line 3, and channel 12 on line 22. T66 (54 36 36) in the
parameter sequence above indicates that the
cots.1
number of lines is 66.
If an undefined parameter code or undefined parameter format is included
in the parameter sequence of this control sequence, the printer regards it
as an invalid load FCB
(EVFU)
data command or invalid control sequence,
and loads the default value (set by the setup) in the FCB. The following
are examples of an undefined parameter format:
Example 1:
The total number of lines is less than 17 or more than 176.
go 23
L1;1;2""""""""";
~16
gc
f
Parameter sequence
Example 2:
A channel other than channels 1 to 12 is specified.
90 23
L1;1;2;L5;53;T66
9C
t
Parameter sequence
Parameters are not separated with semicolons
(;).
. . . . . ...*.
Parameter sequence
6
-
22 B02P-1500-OOOlA...05