Filter
Top Products
TROUBLESHOOTING
TROUBLESHOOTING
Up
Down
Test Mode for Maintenance
5-17
Turn off the power.
Open the ADF.
Turn the power on after setting
the empty sensor and B5 size
sensor as shown in the figure.
NO
YES
Does the POWER lamp blinks?
Close the ADF cover.
(The scanner is placed in the maintenance mode.)
CAUTION
If an operation other than described here is performed, the scanner may malfunction.
Activate the test mode and follow the procedure only for the error status.
Activating a test mode
*1 Do not perform any other operation this time. Immediately turn the power off when the POWER
lamp does not blink.
Try again (*1)
Empty sensor B5 Size sensor
Power
If the CHECK indicator lights up, activate the test mode and inform your sales or
support agent or Fujitsu service representative of the error status.