Filter
Top Products
Ending the test in flatbed mode
Ending the test in ADF mode
To stop the carrier movement in flatbed mode, open the ADF. If the ADF is opened, the POWER
lamp starts blinking immediately after the carrier returns to the home position.
If the ADF hopper is empty, feeding documents from the ADF ends. To restart feeding, open the
ADF and close it again. Then load documents on the ADF paper chute within five seconds after
closing the ADF.
Paper
jam
Carrier
unit
error
Back
optical
system
error
Front
optical
system
error
Motor
fuse
failure
Lamp
fuse
failure
Errors
Status
LED
indicates
Power
Read
Check
Blink On Off
Activating the continuous operation test
LED status on error
If an error occurs during the test, the LED indicates as shown in the following table.
Open the ADF and close it again. If no document is loaded on the ADF within five seconds after
closing the ADF, the image scanner runs in flatbed mode. If documents are loaded on the ADF
within five seconds after closing the ADF, the image scanner continuously feeds the document
from ADF. Once the image scanner starts reading documents in flatbed mode, it does not feed
documents from ADF even if documents are loaded on the ADF.
5-18
NOTE