Filter
Top Products
152
7 Network controller
configured for 10Mb full-
duplex link.
The adapter has been
manually configured for
the selected line speed and
duplex settings.
Informational message
only.
No action is required.
8 Network controller
configured for 100Mb
half-duplex link.
The adapter has been
manually configured for
the selected line speed and
duplex settings.
Informational message
only.
No action is required.
9 Network controller
configured for 100Mb
full-duplex link.
The adapter has been
manually configured for
the selected line speed and
duplex settings.
Informational message
only.
No action is required.
10 Network controller
configured for 1Gb half-
duplex link.
The adapter has been
manually configured for
the selected line speed and
duplex settings.
Informational message
only.
No action is required.
11 Network controller
configured for 1Gb full-
duplex link.
The adapter has been
manually configured for
the selected line speed and
duplex settings.
Informational message
only.
No action is required.
12 Medium not supported. The operating system does
not support the IEEE
802.3 medium.
Reboot the operating
system, run a virus check,
run a disk check (chkdsk),
and reinstall the operating
system.
13 Unable to register the
interrupt service routine.
The device driver cannot
install the interrupt
handler.
Reboot the operating
system; remove other
device drivers that may be
sharing the same IRQ.
14 Unable to map IO space. The device driver cannot
allocate memory-mapped
I/O to access driver
registers.
Remove other adapters
from the system, reduce
the amount of physical
memory installed, and
replace the adapter.
15 Driver initialized
successfully.
The driver has
successfully loaded.
Informational message
only.
No action is required.
16 NDIS is resetting the
miniport driver.
The NDIS layer has
detected a problem
sending/receiving packets
and is resetting the driver
to resolve the problem.
Run BACS2 diagnostics;
check that the network
cable is good.
Message
Number
Message Cause Corrective Action