Filter
Top Products
180
7 Select the standby member from the list of adapters.
The Auto-Fallback Disable mode feature allows the team to continue using the standby
member rather than switching back to the primary member if the primary member comes
back online.
To enable this feature, click "Enable Auto-Fallback Disable mode" and then click [Next].
The Auto-Fallback Disable mode feature is enabled, LiveLink cannot be used.
8 If you want to configure LiveLink, click [Yes] and then click [Next].
If you do not want to configure LiveLink, click [No], and click [Next].
9 Set the probe interval (the number of seconds between each
retransmission of a link packet to the probe target) and the
maximum number of probe retries (the number of consecutively
missed responses from a probe target before a failover is
triggered).