Filter
Top Products
154
7 Could not bind to
adapter.
The driver could not
open one of the team
physical adapters.
Unload and reload the
physical adapter driver,
install an updated
physical adapter driver,
or replace the physical
adapter.
8 Successfully bind to
adapter.
The driver successfully
opened the physical
adapter.
Informational message
only.
No action is required.
9 Network adapter is
disconnected.
The physical adapter is
not connected to the
network (it has not
established link).
Check that the network
cable is connected,
verify that the network
cable is the right type,
and verify that the link
partner (switch or hub) is
working correctly.
10 Network adapter is
connected.
The physical adapter is
connected to the network
(it has established link).
Informational message
only.
No action is required.
11 Broadcom Advanced
Program Features Driver
is not designed to run on
this version of Operating
System.
The driver does not
support the operating
system on which it is
installed.
Consult the driver
release notes and install
the driver on a supported
operating system or
update the driver.
12 Hot-standby adapter is
selected as the primary
adapter for a team
without a load balancing
adapter.
A standby adapter has
been activated.
Replace the failed
physical adapter.
13 Network adapter does
not support Advanced
Failover.
The physical adapter
does not support the
Broadcom NIC
Extension (NICE).
Replace the adapter with
one that does support
NICE.
14 Network adapter is
enabled via management
interface.
The driver has
successfully enabled a
physical adapter through
the management
interface.
Informational message
only.
No action is required.
Message
Number
Message Cause Corrective Action