Filter
Top Products
90 SPARC Enterprise T5140 and T5240 Servers Service Manual • July 2009
Note – Depending on the configuration of ILOM POST variables and whether POST
detected faults or not, the system might boot, or the system might remain at the ok
prompt. If the system is at the ok prompt, type boot.
d. Return the virtual keyswitch to Normal mode.
e. Switch to the system console and type the Solaris OS fmadm faulty
command.
No memory faults should be displayed.
If faults are reported, refer to the diagnostics instructions described in “ILOM
Troubleshooting Overview” on page 23 for guidance in troubleshooting the
fault.
5. Switch to the ILOM command shell.
6. Run the show faulty command.
If the show faulty command reports a fault with a UUID go on to Step 7.If
show faulty does not report a fault with a UUID, you are done with the
verification process.
-> set /SYS keyswitch_state=Normal
Set ‘ketswitch_state’ to ‘Normal’
# fmadm faulty
-> show faulty
Target | Property | Value
--------------------+------------------------+-------------------------------
/SP/faultmgmt/0 | fru | /SYS/MB/CMP0/BR0/CH1/D0
/SP/faultmgmt/0 | timestamp | Dec 14 22:43:59
/SP/faultmgmt/0/ | sunw-msg-id | SUN4V-8000-DX
faults/0 | |
/SP/faultmgmt/0/ | uuid | 3aa7c854-9667-e176-efe5-e487e520
faults/0 | | 7a8a
/SP/faultmgmt/0/ | timestamp | Dec 14 22:43:59
faults/0 | |