Filter
Top Products
74 SPARC Enterprise T5140 and T5240 Servers Service Manual • July 2009
Note – SPARC Enterprise T5140 servers might have up to seven blank panels
covering unoccupied drive slots. SPARC Enterprise T5240 servers might have as
many as fifteen blank panels covering unoccupied hard drive slots.
2. Align the replacement drive to the drive slot.
Hard drives are physically addressed according to the slot in which they are
installed. If you install a hard drive as a replacement for a drive that was removed,
the new drive must go into the same slot as the drive it is replacing.
FIGURE: Installing a Hard Drive (Illustrating Installation in a SPARC Enterprise T5240
Server)
3. With the latch open, slide the hard drive into its bay until it is fully seated.
Then close the latch to secure the drive.