Filter
Top Products
94 SPARC Enterprise T5140 and T5240 Servers Service Manual • July 2009
c. Switch to the system console to view POST output.
Watch the POST output for possible fault messages. The following output is a
sign that POST did not detect any faults:
Note – Depending on the configuration of ILOM POST variables and whether POST
detected faults or not, the system might boot, or the system might remain at the ok
prompt. If the system is at the ok prompt, type boot.
d. Return the virtual keyswitch to Normal mode.
Related Information
■ “Remove FB-DIMMs” on page 84
■ “Install Replacement FB-DIMMs” on page 86
■ “Verify Successful Replacement of Faulty FB-DIMMs” on page 88
■ “FB-DIMM Configuration Guidelines for SPARC Enterprise T5140 Servers” on
page 94
■ “FB-DIMM Configuration Guidelines for SPARC Enterprise T5240 Servers” on
page 98
FB-DIMM Configuration Guidelines for SPARC
Enterprise T5140 Servers
When planning FB-DIMM upgrades to SPARC Enterprise T5140 servers, observe the
following memory configuration guidelines:
■ The motherboard has 16 slots that support industry-standard FB-DIMMs.
■ Use only 1.5-volt FB-DIMMs in SPARC Enterprise T5140 and T5240 servers.
-> start /SYS/console
.
.
.
0:0:0>INFO:
0:0:0> POST Passed all devices.
0:0:0>POST: Return to VBSC.
0:0:0>Master set ACK for vbsc runpost command and spin...
-> set /SYS keyswitch_state=Normal
Set ‘ketswitch_state’ to ‘Normal’