Filter
Top Products
152 SPARC Enterprise T5140 and T5240 Servers Service Manual • July 2009
You must remove the hard drive cage to access the following components:
■ Hard drive backplane
■ Front control panel light pipe assemblies
Related Information
■ “Remove the Hard Drive Cage” on page 152
■ “Install the Hard Drive Cage” on page 154
■ “Remove the Hard Drive Backplane” on page 157
■ “Remove the Front Control Panel Light Pipe Assemblies” on page 161
▼ Remove the Hard Drive Cage
1. Power off the system.
See “Removing Power From the System” on page 60.
2. Disconnect all external cables.
3. Remove the server from the rack. Place the server on a hard, flat surface.
See “Remove the Server From the Rack” on page 64.
4. (SPARC Enterprise T5140) Remove the inner glides from the server.
Each inner glide is secured with a locking tab. Release the tab and slide each inner
glide off the server mounting studs.
5. Attach an antistatic wrist strap.
6. Remove the top cover.
See “Remove the Top Cover” on page 67.
7. If you are servicing the hard drive backplane, remove all hard drives.
See “Remove a Hard Drive” on page 71.
Note – Make a note of the drive locations before removing them. You will need to
install the hard drives in the same locations when reassembling the system.
8. If you are servicing the hard drive backplane, remove the DVD/USB module.
See “Remove the DVD/USB Module” on page 145.