Filter
Top Products
Servicing Motherboard Components 93
11. Install the top cover.
See “Install the Top Cover” on page 177.
12. Slide the server into the rack.
See “Return the Server to the Normal Rack Position” on page 180.
13. Connect the power supplies.
See “Connect Power Cords to the Server” on page 181.
Note – As soon as the power cords are connected, standby power is applied.
Depending on how the firmware is configured, the system might boot at this time.
14. Power on the server.
See “Power On the Server Using the poweron Command” on page 181 or “Power
On the Server Using the Front Panel Power Button” on page 182.
15. Perform the following steps to verify that there are no faults:
a. Set the virtual keyswitch to diag so that POST will run in Service mode.
b. Power cycle the system.
Note – The server takes about one minute to power off. The ILOM console does not
indicate when the system is actually powered off.
-> set /SYS/keyswitch_state=Diag
Set ‘keyswitch_state’ to ‘Diag’
-> stop /SYS
Are you sure you want to stop /SYS (y/n)? y
Stopping /SYS
-> start /SYS
Are you sure you want to start /SYS (y/n)? y
Starting /SYS