Filter
Top Products
86 SPARC Enterprise T5140 and T5240 Servers Service Manual • July 2009
FIGURE: Removing FB-DIMMs
8. Grasp the top corners of the faulty FB-DIMM and lift it out of its slot.
9. Place the FB-DIMM on an antistatic mat.
10. Repeat Step 7 through Step 9 for any other FB-DIMMs you intend to remove.
11. If you do not plan to install replacement FB-DIMMs at this time, install filler
panels in the empty slots.
Related Information
■ “Install Replacement FB-DIMMs” on page 86
■ “Verify Successful Replacement of Faulty FB-DIMMs” on page 88
▼ Install Replacement FB-DIMMs
Before beginning this procedure, ensure that you are familiar with the information
provided in these topics:
■ “Preparing to Service the System” on page 57
■ “FB-DIMM Configuration Guidelines for SPARC Enterprise T5140 Servers” on
page 94
Note – If the server is already extended and open, begin the procedure at Step 4.
1. Extend the server to the maintenance position.
See “Extend the Server to the Maintenance Position” on page 63.