Filter
Top Products
154 SPARC Enterprise T5140 and T5240 Servers Service Manual • July 2009
13. Lift the hard drive cage up and out of the chassis.
14. Set the hard drive cage on an antistatic mat.
Related Information
■ “Install the Hard Drive Cage” on page 154
■ “Remove the Hard Drive Backplane” on page 157
▼ Install the Hard Drive Cage
Before performing any installation steps, review the proper cable routing and
connections. The following topics contain detailed cable routing information.
■ “Internal Cables for Onboard SAS Controller Cards in SPARC Enterprise T5140
Servers” on page 190
■ “Internal Cables for Onboard SAS Controller Cards in SPARC Enterprise T5240
Servers” on page 204
1. Position the hard drive cage in the chassis, over the chassis standoffs.
This is shown in the following figure.