Filter
Top Products
146 SPARC Enterprise T5140 and T5240 Servers Service Manual • July 2009
2. Unplug the power cords.
3. Attach an antistatic wrist strap.
4. Remove the hard drives that are adjacent to the DVD/USB module.
The HDD number will vary, depending on the backplane type.
■ 4-disk capable backplane: remove HDD3
See “Four-Drive Capable Backplane Configuration Reference” on page 77.
■ 8-disk capable backplane: remove HDD7
See “Eight-Drive Capable Backplane Configuration Reference” on page 78.
■ 16-disk capable backplane: remove HDD13
See “Sixteen-Drive Capable Backplane Configuration Reference” on page 79.
5. Release the DVD/USB module from the hard drive backplane.
Use the finger indentation in the hard drive bay below the DVD/USB module to
extend the release tab.
FIGURE: Removing the DVD/USB Module (illustrates removal from a SPARC Enterprise
T5140 server)