Filter
Top Products
Detecting and Managing Faults 31
PSH Technology
Related Information
■ “Clear FRU Faults Manually” on page 31“Display FRU Information With the show
Command” on page 32
▼ Clear FRU Faults Manually
Use the clear_fault_action property of a FRU to manually clear faults recorded
in a FRU PROM. There are two conditions where this step may be needed:
■ To clear a fault diagnosed by the predictive self-healing feature without replacing
the faulty FRU.
■ To clear a fault that the service processor was unable to clear following a FRU
replacement.
Note – This procedure clears the fault from the service processor but not from the
host. If the fault persists in the host, it must be manually cleared.
● At the -> prompt, enter the clear_fault_action property.
Related Info
■ “Clear PSH-Detected Faults” on page 47
-> show faulty
Target | Property | Value
--------------------+------------------------+-------------------------------
/SP/faultmgmt/0 | fru | /SYS/MB/CMP0/BR0/CH1/D0
/SP/faultmgmt/0 | timestamp | Dec 14 22:43:59
/SP/faultmgmt/0/ | sunw-msg-id | SUN4V-8000-DX
faults/0 | |
/SP/faultmgmt/0/ | uuid | 3aa7c854-9667-e176-efe5-e487e520
faults/0 | | 7a8a
/SP/faultmgmt/0/ | timestamp | Dec 14 22:43:59
faults/0 | |
-> set /SYS/MB/CMP0/BR0/CH0/D0 clear_fault_action=True
Are you sure you want to clear /SYS/MB/CMP0/BR0/CH0/D0 (y/n)? y
Set ’clear_fault_action’ to ’true’