Filter
Top Products
Returning the Server to Operation 181
Related Information
■ “Reinstall the Server in the Rack” on page 178
■ “Connect Power Cords to the Server” on page 181
■ “Power On the Server Using the poweron Command” on page 181
■ “Power On the Server Using the Front Panel Power Button” on page 182
▼ Connect Power Cords to the Server
● Reconnect both power cords to the power supplies.
Note – As soon as the power cords are connected, standby power is applied.
Depending on how the firmware is configured, the system might boot at this time.
Related Information
■ “Power On the Server Using the poweron Command” on page 181
■ “Power On the Server Using the Front Panel Power Button” on page 182
▼ Power On the Server Using the
poweron Command
Note – If you are powering on the server following an emergency shutdown that
was triggered by the top cover interlock switch, you must use the poweron
command.