Filter
Top Products
Servicing Motherboard Components 127
a. All FB-DIMMs removed from the previous motherboard. Ensure that the
FB-DIMM modules are installed in the same memory configuration as they
were in before.
See “FB-DIMM Configuration Guidelines for SPARC Enterprise T5140 Servers”
on page 94 or “FB-DIMM Configuration Guidelines for SPARC Enterprise
T5240 Servers” on page 98 for guidance.
b. SCC module. See “Install the SCC Module” on page 117.
6. Connect the hard drive data cables. For cable routing instructions, see
whichever of the following topics apply:
■ “Internal Cables for Onboard SAS Controller Cards in SPARC Enterprise T5140
Servers” on page 190
■ “Internal Cables for Onboard SAS Controller Cards in SPARC Enterprise T5240
Servers” on page 204
7. Install the air duct.
See “Install the Air Duct” on page 104.
8. Reinstall the motherboard-to-power distribution board ribbon cable.
9. Reinstall the PCIe and XUAI risers.
See “Install a PCIe/XAUI Riser” on page 107.
10. Install the top cover.
See “Install the Top Cover” on page 177.
11. Install the server into the rack.
See “Reinstall the Server in the Rack” on page 178.
12. Attach the power cables.
See “Connect Power Cords to the Server” on page 181.
13. Power on the server.
See “Power On the Server Using the poweron Command” on page 181 or “Power
On the Server Using the Front Panel Power Button” on page 182.
Related Information
■ “Remove the Motherboard Assembly” on page 123