Filter
Top Products
108 SPARC Enterprise T5140 and T5240 Servers Service Manual • July 2009
FIGURE: Installing the PCIe/XAUI Riser (SPARC Enterprise T5240)
2. Ensure that the PCIe back panels are properly engaged with the corresponding
slots in the motherboard tray/back panel connector assembly.
3. Tighten the captive screw to secure the riser to the motherboard.
4. Install the PCI cross beam.
Slide the cross beam forward over the PCIe/XAUI risers. Ensure that the cross
beam is engaged with the standoffs on either side of the chassis rear panel PCI
cross beam.
5. Tighten the two captive Phillips screws securing the removable PCI cross beam
to the chassis.
6. Install the top cover.
7. Slide the server into the rack.
See “Return the Server to the Normal Rack Position” on page 180
8. Connect any data cables you removed to service the PCIe/XAUI cards.
9. Connect all power cables.
Related Information
■ “Remove a PCIe/XAUI Riser” on page 105
■ “Remove a PCIe or XAUI Card” on page 109
■ “Install a PCIe or XAUI Card” on page 109