Filter
Top Products
166 SPARC Enterprise T5140 and T5240 Servers Service Manual • July 2009
6. (SPARC Enterprise T5240 server) Remove the four No. 2 Phillips screws
securing the power distribution board to the power supply backplane.
7. Remove the No. 2 Phillips screw securing the power distribution board to the
chassis as shown in the following figure.
FIGURE: Removing the Power Distribution Board From a SPARC Enterprise T5140 Server
8. Grasp the bus bar and pull the power distribution board/bus bar assembly to
the left, away from the paddle card.
9. Lift the power distribution board/bus bar assembly up and out of the system.
10. Place the power distribution board/bus bar assembly on an antistatic mat.
Related Information
■ “Install the Power Distribution Board” on page 167