Filter
Top Products
Non-Windows software
Since each program differs in its setup capabilities, there is no
standard way to select the printer driver. See your software
manual for information on how to select an HP LaserJet 4
driver.
Using the serial interface
If you are using the serial interface, you need to ensure that the
printer and the computer are using the same serial settings. If
the serial settings do not match, you must change the
appropriate settings. The settings can be changed either at the
printer or computer.
The printer’s default serial settings are listed below. To change
the printer’s serial settings, see “SERIAL MENU” in Chapter 4
of the Reference Guide. For information about your computer’s
serial settings, see your computer manual.
serial
Word length
Baud rate
Parity
Stop bit
DTR
XON/XOFF
DSR
RS-232C
8
NONE
1
OFF
ON
OFF
You also need to change the port setting at your computer if it
is not already selected for the serial port. The following
procedure describes how to change the port setting in
Windows. To change the setting using non-Windows software,
see your software manual.
1.
In the
Main
window, doubleclick on the
Control Panel
icon.