Filter
Top Products
Magnum 6K25e Gigabit Fiber Switch Installation and User Guide (10/07)
11
www GarrettCom com
..
eliminate the need of cross-over cable.
On the model 6K8-RJ45 module, there are four LEDs for each port, two in the
connector and two separate. The LK (Link) LED indicates “ready for operation” on that
port when lit. The blinking ACT (Activity) LED indicates receiving Activity on that port
when lit. The 10/100 LED indicates operation at 100Mb speed when ON and at 10 Mb
speed when OFF (when auto-
negotiation is not disabled).
The FDX/HDX LED is ON
to indicate full-duplex
operation and OFF to indicate
half-duplex mode. A twisted
pair cable must be connected
into an RJ-45 port and the Link (LK) indicator for that port must be ON (indicating there
is a powered-up device at the other end of the cable) in order for a LK LED to provide
valid indications of operating conditions on that port.
Using the 6K8-Series (MNS-6K) management software, the user may disable
auto-negotiation and fix the desired operation of each RJ-45 port. User may select 10Mb
or 100Mb speed and full- or half-duplex mode per-port as per user requirement. (See
Magnum MNS-6K Software Manual for details info.).
2.2.4 New PoE(Power Inside), model PI6KP8-45RJ (MDIX), 10/100Mb 8-port
The New PoE RJ-45 ports act similar to regular RJ-45 ports, except they have
capability of providing power on each port to power up the PD devices, per the
IEEE802.3af PoE
standard. Only 4 x RJ-
45 (10/100) ports
maxm. support
POE(Power Inside)
option in one rack
mounted 6K-unit. The
power inside PoE
option is factory
configured and
equipped with the
necesasary power
option to support four
802.3af PoE pd devices.
The 4-RJ45 POE
module are also available with mix –n-match with fiber modules. Please check the
1 3 5 7
10/100
LK
F/H
ACT
10/100
LK
2 4 6 8
F/ H
ACT
6KP8-45RJ
8 Port@ 10/100Mb Copper ports
4
4
FULL/HALF
1
PoE
LINK
LK
/
ACT
2
3
10/10
2
1 3 5
10/10
LK/AC
1
3
F/H
POE
10/10
LK/AC
2 4 6
F/ H
POE