Filter
Top Products
Magnum 6K25e Gigabit Fiber Switch Installation and User Guide (10/07)
53
www GarrettCom com
..
4
3
2 4 6
LK
2
ACT
F/H
ACT
F/H
6KP8V-6KP8-45-2MT
6 Port
@
10/10Mb
p
s & 2 port @100Mb
Multi-Mode Fiber port
1 3 5
10/10
L
1
F/H
AC
4
FULL/HALF
1
ACTIVITY
LINK
2
3
10/100
10/100
F/H
When non-PoE devices are connected, the PoE LED is OFF. Operation of Ethernet data
traffic is not affected by PoE.
LINK and ACTIVITY LEDS are combined on the PoE modules into one LED
that is marked as LINK/ACT, as shown in the diagram.
PoE LEDs Summary
For PoE devices, each RJ-45 PoE port supports only 802.3af complaint
devices. The PoE LED is ON when the attached PD is drawing power from the
port.
For non-PoE devices connected, the PoE port will act as a normal RJ-45 port
and the PoE LED is OFF. No power is being sent out from the port.
The PoE ports in Magnum 6K’s with 48VDC power input act as a pass-
through, so the 48VDC power source must be strong enough to provide power
to the 6K switch and to all the 8 RJ-45 ports with PD devices connected (up to
15 watts per PoE port).
In the case where the 48VDC power in not internally connected and no power
is coming to the PoE ports for some reason, all the PoE port LEDs are ON
simultaneously to indicate a trouble condition. The ports will still operate
properly for data traffic.
5.2.12 6KP8-45-2MT, 6@ 10/100Mbps RJ-45 and 2@100Mb multi-mode
FX , MTRJ Small-Form-Factor
The Magnum 6KP8-
45-2MT eight port Module is a
combo module with copper and
fiber (Small Form Factor)
MTRJ type ports. The small
sizes of MTRJ connectors give
an advantage of placing more
fiber ports on one module. The
6KP8-45-2MT is equipped with
six 10/100 RJ-45 ports and two
100Mb MTRJ fiber ports. When installed in a Magnum 6K25e Switch, it supports the
standard distances as mentioned on 5.2.3. and the LEDs also act similarly.
5.2.12a 6KP8-45-2LC, 6@ 10/100Mbps RJ-45 and 2@100Mb single-mode
FX , LC Small-Form-Factor