Filter
Top Products
Magnum 6K25e Gigabit Fiber Switch Installation and User Guide (10/07)
14
www GarrettCom com
..
1 3 5 7
10/100
L
F/
ACT
TX RXL
K
ACT
F/
TX RXL
ACT
F/
TX LK RX
ACT
F/
TX RXL
K
ACT
F/
fiber modules except for the 10Mb speed. For ports numbering, ports 1, 2, 5, 6 are
present, ports 3, 4. 7, 8 are not present. The default setup on the 10Mb fiber module is
half-duplex, which allows the Magnum 6K25e Switch to connect to any 10Mb hub or
media converter or almost any other device with a 10Mb fiber Ethernet port. User mode
control per port through the MNS software is the same as the other 6K25e modules. The
fiber ports support fiber cabling distances according to the 10BASE-FL standard, i.e.,
2km distance for multi-mode fiber. (Single-mode for up to 10Km distance may be
available as a special order configuration).
2.2.8 Gigabit (1000Mbps) port modules
The Magnum 6K25e offered a wide option Gigabit speed with multiple choice
for the modular slot. While up to two Gigabit modules (maxm.) can be configured in the
modular slot. The Gigabit port option for the modular slot comes in couple of different
configuration. The Giga port has been offered
as single Gigabit module comes in flavor of
G+4(10/100 RJ-45 ports) or G+2 (100Mb fiber
ports) as shown below .
1@ 1000Mb Fiber SC + 2@ 100Mb SC
The 6K25e Modules provide a GBIC opening for insertion of industry-standard
GBICs to provide Gigabit (Gb) media flexibility. GBIC models are available for both
multi-mode (550m) and single-mode (10, 25, 40, 70)km fiber options, and for Gigabit
copper as well, with new models appearing often.
The 1000Mb Gigabit fiber-port
modules on the Magnum 6K25es are
normally set (factory default) to operate at
AUTO mode for best fiber distance and
performance. The 1000Mbps SC fiber-optic
module on the Gigabit -SX and Gigabit-LX 1@ 1000Mb Fiber SC + 4@10/ 100Mb
transceivers are compatible with the IEEE 802.3z Gigabit standards.
There are two LEDs mounted on each Gigabit port module. The Gigabit fiber
port is by default configured at AUTO mode, and can be fix at 1000Mbps speed full-
duplex mode at any times and has LEDs that indicate LK (Link status) and ACT
(receiving activity) on that port when lit.