Filter
Top Products
19
Installing the autoloader into a cabinet
www.gateway.com
Preparing the autoloader
To prepare the autoloader for installation:
1 Use the eraser end of a pencil, or a similar object, to press the right side
of the recessed power switch on the front of the autoloader. This turns off
the autoloader.
2 Remove the power cord and any SCSI cables or terminators attached to
the autoloader. Note the configuration of the cables and terminator. You
will reinstall them after installing the autoloader in the cabinet.
Warning Before performing any installation or maintenance
procedures, make sure that the autoloader is turned off
and that the power cord is unplugged from the autoloader
and the AC outlet.
Important To avoid disrupting communication between the host
computer and other devices on the SCSI bus, make sure
that there is no SCSI activity on the bus before you turn
off the autoloader.