Filter
Top Products
22
Chapter 3: Setting Up the Autoloader
www.gateway.com
Installing the cabinet mount brackets
To install the cabinet mount brackets on the autoloader:
1 Remove the cabinet mount brackets from the cabinet mount kit and
determine which side of the autoloader you will attach them to:
a From the front of the cabinet, slide the autoloader partially onto the
shelf flanges between the support rails you just installed.
b Holding one of the cabinet mount brackets against one side of the
autoloader, line up the two holes in the bracket with the two screw
holes on the side of the autoloader. The flange on the bracket should
be toward the front of the autoloader, facing outward.
c Slide the autoloader into the cabinet until the bracket contacts the
cabinet’s mounting holes.
d Determine whether the screw hole on the bracket flange lines up with
a mounting hole in the cabinet. If it does, you will mount the bracket
on that side of the autoloader. If not, you will mount it on the other
side of the autoloader.
2 Remove the autoloader from the shelf and place it on the work surface.
3 Using a TORX T-10 screwdriver, remove the two screws on each side of
the autoloader.