Filter
Top Products
www.gateway.com
35
4 Align the notch on the new module with the notch in the memory module slot, then press
the module firmly into the slot. The tabs on the sides of the memory slot should secure
the memory module automatically.
5 Follow the instructions in “Closing the server case” on page 26.
6 Turn on the server and open the BIOS setup utility. Verify the System Memory listed in
the Main menu. When you exit the BIOS setup utility make sure that the operating system
completely loads. If you receive an error, see “Installing memory” on page 32.
Installing and removing PCI expansion cards
The system board provides one PCI-E x16 with x8 speed, two PCI-E x8 with x4 speed, two PCI-X
64-bit/66 MHz, and one PCI 32-bit/33 MHz expansion slots.
Removing and installing a PCI card
To remove and reinstall a PCI expansion card:
1 Follow the instructions in “Preventing static electricity discharge” on page 24. Make sure
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
2 Follow the instructions in “Opening the server case” on page 25.
3 If you are removing and installing a full-length card, press the clips (1) on the card guide
tab, then rotate the card guide tab (2) up to release the PCI expansion cards. Otherwise,
go the next step.
Caution
PCI expansion cards are not hot-swappable. Before installing or removing a PCI card,
make sure that power is turned off and the power cords are unplugged.