Filter
Top Products
CHAPTER 4: Installing Components
26
6 Loosen the two thumbscrews (1) on the back of the cover.
7 Slide the cover (2) toward the back of the case, then remove it from the case.
Closing the server case
To close the server case:
1 Make sure that all of the internal cables are arranged inside the case so they will not be
pinched when you close the case.
2 Place the cover on the side of the case, then slide it forward until it snaps into place.
3 Tighten the two thumbscrews to hold the cover in place.
4 Lock the case cover lock on the front panel of the case, then close the bezel.
5 Reconnect the power cords and all other cables.
Installing and removing drives
Your server’s basic configuration includes one optical drive and as many as 10 3.5-inch SATA or
SAS hot-swap hard drives. You can also add an optional diskette drive.
As you prepare to install drives, remember:
• Before you install a drive, see the drive’s documentation for information on configuring
the drive, setting drive jumpers, and attaching cables.
• You may need to configure the drives you install using the BIOS Setup utility. Press F2 at
startup to open the BIOS Setup utility.