Filter
Top Products
Installation
ORCA-IV Image Transfer Laminator Operation Manual
2-4
© GBC Pro-Tech 1998 October
8QSDFNLQJ
☞
NOTE
ALL SHIPMENTS ARE EX- WORKS. At our dock title
passes to the buyer Please review your insurance cov-
erage prior to shipment, as you are responsible for all
subsequent freight charges and risks. Before signing
the Bill of Lading you should be sure to inspect the
machine for signs of damage or missing items; if appli-
cable, you should make a note of this on the Bill of Lad-
ing.
The ORCA-IV Image Transfer Laminator is shipped
encased in shrink wrap via Air Ride Van.
To unpack the machine:
7. Have the image transfer laminator rolled off the
Air Ride Van and placed on the floor by licensed
riggers.
IMPORTANT
8. Gently unwrap the shrink wrap from around the
image transfer laminator and remove the foam pro-
tecting the corners of the machine.
IMPORTANT
9. Carefully remove any accessories packed with the
machine. The accessory pack should contain:
1 Towel, white
1 Slitting knife
1 Set, hex wrenches
4 Leveling pads
3 Fuses (6A, 250V)
1 Tape measure
1 Rubber cement pick-up
1 Strain relief
1 Manual
4 Slitter Assemblies
2 T-handle wrenches (
1
/
4
")
2 Web unwind spacers
10. Remove any plastic strapping and packing paper
taped to the
roll
s.
IMPORTANT
11. Remove all packing materials to a safe distance
from the image transfer laminator.
12. Level the machine using the procedure included in
this section.
Do not attempt to move the image transfer
laminator across anything other than a flat, level
surface without trained and qualified riggers.
You can be crushed or seriously injured.
The ORCA-IV Image Transfer Laminator is a
large and heavy piece of equipment. It is
necessary to employ LICENSED RIGGERS
ONLY to move the machine. The image transfer
laminator is not designed to be tipped up or
sideways in any way. Such action disturbs the
exact alignment of the rolling parts of the
machine and requires extensive realignment.
GBC Pro-Tech’s warranty does not cover
malfunction of the equipment due to mishandling
and/or tipping.
GBC Pro-Tech bears no responsibility for
personal injury or damage due to moving the
image transfer laminator improperly.
Do not use a knife or other sharp instrument
during installation or while servicing the image
transfer laminator. You can cause irreparable
damage to the rolls.
Do not use a knife or other sharp instrument
during installation or while servicing the image
transfer laminator. You can cause irreparable
damage to the rolls.