Filter
Top Products
ORCA-IV Image Transfer Laminator Operation Manual
Specifications
© GBC Pro-Tech 1998 October
6-1
6HFWLRQ6SHFLILFDWLRQV
Table 6-1: ORCA-IV Image Transfer Laminator
Specifications
Characteristic
Specifications
Dimensions
(L x D x H)
86" x 48" x 73"
(2.2 x 1.2 x 1.7 m)
Weight Uncrated: 3060 lbs (1814 kg)
Main Rolls 62" (157 cm) roll face with high
release silicon rubber coating for
54" wide materials
Main Roll Open-
ing
1.25" (3.2 cm) maximum open-
ing
Material Uses transfer materials 0 - 54"
(0 - 137.2 cm) wide. Handles
materials on 3" (7.6 cm) ID cores
with material diameters up to 15"
(38.1 cm).
Speeds 0 to 10 fpm (0 to 3.1 mpm)for
transfer process with variable
speed and 19 fpm (5.8 mpm) ,
reversible action, start and stop
controlled by the instrument
panel.
Safety Features • All electrical and moving
mechanical parts are located
in bolted cabinets
• Emergency stop buttons with
a reset button circuit
• Fully guarded with inter-
locks
• Emergency stop kick cables
Options • Preheater module
Installation
Requirement
230VAC 50 or 60 Hz, three
phase, 45A per phase with pre-
heater (35A per phase without
preheater) for 4 wire delta
hookup. 40A service without the
preheater and 50A service with
the preheater is required.
Filtered air at 1.5 cubic feet per
minute (cfm), 50 liters/minute at
a pressure of 100 pounds per
square inch (psi) (700 kPa)