Filter
Top Products
ORCA-IV Image Transfer Laminator Operation Manual
Operation
© GBC Pro-Tech 1998 October
3-5
8. ROLL TEMPERATURE - Provides a readout of
the temperature of the upper main roll and the set-
point for the desired temperature adjustment. Press
the star button on the temperature controller to see
or change the set point.
9. ROLL HEAT ON/OFF - Turns the heater control-
ler for the top roll on or off.
10. PULL ROLL UP/DOWN - Sets the pull roll to
the up (load) or down (operate) position.
11. COOLING FAN ON/OFF - Turns the cooling fan
on or off. Push once to turn only the cooling idlers
on, push again to turn only the cooling tubes on,
push a third time to turn both cooling idlers and
cooling tubes on, and push a fourth time for all
cooling off.
12. PREHEATER AIR TEMPERATURE
(optional) - Provides a readout of the temperature
of the air inside the preheater and the set-point for
the desired temperature.
13. PREHEATER HEAT ON/OFF - Turns the heater
controller in the preheater roll on or off.
14. ACCUMULATOR RESET - Resets the accumu-
lator.
15. SPEED/ACCUMULATOR TOGGLE - Toggles
control between the speed and the accumulator.
16. MOTION CONTROL FORWARD/STOP/
REVERSE - Controls the direction of the drive
system, forward, reverse, or stop.