Filter
Top Products
3
(THE FOLLOWING NOTE APPLIES ONLY
TO THE UNITS RATED 115V 60HZ.)
This equipment has been tested and found
to comply with the limits for a Class A
digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference when the equipment
is operated in a commercial environment.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
Operator Manual, may cause harmful
interference to radio communications.
Operation of this equipment in a residential
area is likely to cause harmful interference
in which case the user will be required to
correct the interference at his/her own
expense.
CAUTION: CHANGES
OR MODIFICATIONS NOT
EXPRESSLY APPROVED
BY GENERAL BINDING
CORPORATION COULD VOID
YOUR AUTHORITY TO OPERATE
THE EQUIPMENT.
This Class A digital apparatus meets all
requirements of the Canadian Interference-
Causing Equipment Regulations.
By purchasing the PF-3200, you have
invested in a highly capable binding
machine that will give you years of reliable
service. To help protect this investment be
certain to take advantage of the GBC
Equipment Maintenance Agreement
(EMA). The EMA provides your PF-3200
with proper ongoing maintenance and
care, helping to ensure the years of quality
performance and long life built into the
machine. Without an EMA, a charge for
time and labor would result from every
normal maintenance or repair service call.
An EMA for your PF-3200 eliminates this
possibility by providing you with a low,
fixed annual cost for protecting your
valuable machine investment. For full
details about purchasing an EMA, contact
your local GBC Branch Office or contact:
General Binding Corporation
500 Bond Street
Lincolnshire, IL 60069
Or Call: 1-800-790-7787
(THE FOLLOWING NOTE APPLIES ONLY
TO THE UNITS RATED 220V 50HZ.)
CAUTION: WHEN CHOOSING A
DETACHABLE LINE CORD FOR
USE WITH YOUR PF-3200,
ALWAYS OBSERVE THE
FOLLOWING PRECAUTIONS:
The cordset consist of three parts; the
attachment plug, cordage and appliance
inlet. Each of these components must
have European regulatory approvals for
safety.
The following minimum electrical ratings
for the specific cordset are published for
safety purposes. DO NOT USE
CORDSETS THAT DO NOT MEET THE
FOLLOWING MINIMUM ELECTRICAL
REQUIREMENTS.
PLUG: 3 ampere, 250 volts, 50/60 Hz,
Class 1, 3 conductor, European safety
approved.
CORDAGE: Type H03VV-F3G0.75,
Harmonized ( < HAR > ). The “< >”
symbols indicate cordage approved to
appropriate European standard (NOTE:
“HAR” may be substituted for approval
mark of European safety agency which
approved the cordage. An example would
be “ < VDE > ”.)
APPLIANCE CONNECTOR: 3 ampere,
250 volts, 50/60 Hz, European safety
approved, Type IEC 320. The cordset
shall not exceed 3 meters in length. A
cordset with component electrical ratings
greater than the minimum specified
electrical ratings may be substituted.
MAIN CORDSET SELECTION FCC NOTE EQUIPMENT MAINTENANCE AGREEMENT