Open as PDF
MULTILINK ETHERNET COMMUNICATIONS SWITCH – QUICKSTART GUIDE 33
Z Select the Enter key.
The switch will ask if you would like to reboot the switch.
Z Select Y for yes and Y again to save the new settings.
Z Once the switch has completed a reboot, the new IP and subnet
mask will be in effect.
Once the switch has rebooted you will need to log in again. To confirm that the IP address
and subnet mask were saved correctly enter the command show setup followed by the
Enter key. The Multilink switch will then provide an on-screen list of the switch settings
including the switch IP address and subnet mask and if programmed, the default gateway.
Once you have verified that the IP, subnet mask and default gateway settings are correct
you can configure the switch via the web interface.
8.2 Assigning a static IP Address to a personnel computer