Filter
Top Products
Programming the Scanner
3-10
User Defined Code ID
This section allows the user to define and program a Code ID
that is different from the Code ID default.
To specify a one-character Code ID, scan in the 2-digit hex
value for that character. Then scan “END.” The hex value can
be determined by referring to the HEX/ASCII Reference Table
on page A-6.
To specify a two-character Code ID, scan the 2-digit hex
values for each of the desired characters. Then scan “END.”
If you only want to assign a one-character Code ID for UPC-E
or EAN-8, scan the two-digit hex code for the desired
character. Then Scan “FIN” and “END” bar codes.
Note: To transmit the Code ID, you have to enable Code ID
transmission on page 3-12.