Filter
Top Products
Type D:\setup and click “OK”. (Note, if your CD is not drive “D” then you should
type that letter instead of “D”.)
The Install program will install the Quick Check
®
PC software onto your hard
drive. You will have the option of selecting an alternate location or
folder/directory name for installation. If you choose this option, be sure to make
a note of the location you selected for future reference.
Once installation is complete, remove the Quick Check
®
CD ROM and re-
enable any virus checkers.
1. Turn on the interface module (press the Power button).
2. Start the Quick Check
®
PC software.
Double-click the Quick Check
®
PC icon in the Quick Check
®
PC window to
start the Quick Check
®
PC software. Or
• In Windows, start Windows Explorer or click on My Computer and locate
the QCPC32 folder. The default location is C:\Program
Files\HHP\QCPC. Double-click the folder to open it then double-click
QCPC32.EXE.
3. Select the Com port.
• Click the “Configure” icon or select Settings, Configure from the
command menu. Select the proper Com port, click “OK” to close the
menu. Quick Check
®
PC default is “No Com Port” on installation.
If you have not already done so, turn on the interface unit and start the Quick
Check
®
PC software.
• Scan the calibration page (use with the Mouse Wand) to begin the
calibration process. Ten consecutive scans are required for calibration.
An audio tone indicates a successful scan. Screen prompts will advise
you of your progress. Note, if scans are too variable, you will have to
start over.
• When the calibration is completed, the calibration screen will disappear.
1. Select symbologies, options, quality measures, and other parameters for a
specific verification procedure.
• Position the cursor over each variable parameter. (Note: the cursor
changes to a “screwdriver” over any area that has user-definable
parameters -- see the appropriate section under “Installation and Setup”
for details.)
Right-click to bring up a pop-up menu to set parameters.
• Select the desired parameters.
• Click “OK” when done with each parameter (or “Cancel” if you've
brought up the menu by mistake).
5