Filter
Top Products
7
Switch Overview
Installing the Switch
1. Connect the power cord supplied with the switch to the power connector
on the back of the switch, and then into a properly grounded electrical
outlet
2.) Check the LEDs on the switch as described below.
When the switch is powered on, it performs its diagnostic self test. Self
test takes approximately 50 seconds to complete.
Self Test LED Behavior:
During the self test:
• Initially, all the status, LED Mode and port LEDs are on for most of
the duration of the test.
• Most of the LEDs go off and then may come on again during phases
of the self test. For the duration of the self test, the Test LED stays on.
When the self test completes successfully:
•The Power and Fan Status LEDs remain on.
•The Fault and Test LEDs go off.
• The port LEDs on the front of the switch go into their normal opera-
tional mode:
– If the ports are connected to active network devices the Link
LEDs should be on.
– In the default LED Mode (Act), link activity is displayed on the
Port Mode LED.
Connect power cord to
the power connector
Power
Fault
Locator
Console
10/100Base-T Ports (1 - 24) Ports are HP Auto MDI-X
*
Spd mode: off = 10 Mbps, flash = 100 Mbps, on = 1000 Mbps
12
10
8
6
4
2
11
9
7
5
3
1
Link
Mode
Link
Mode
2220
18
16
14
21
19
17
15
13
Link
Mode
Link
Mode
LED
Mode
Clear
Reset
Test
FDx
Spd
Act
*
ProCurve Switch
2510-24
J9019A
Switch 2510-24
Test LED
Power and
Fault LEDs
Port Mode LED
Port Link LED