HP (Hewlett-Packard) 2510 Switch User Manual


 
1
Switch Overview
Switch Hardware Features
Switch Overview
Switch Hardware Features
The ProCurve Series 2510-24 Switch (Switch 2510-24 (J9019A)) is a store and
forward, multiport switch offering low latency for high-speed networking.
Switch Ports
The Switch 2510-24 has 24 auto-sensing 10/100Base-TX RJ-45 ports, and two
dual-personality ports—either auto-sensing 10/100/1000Base-T RJ-45 or mini-
GBIC.
The dual-personality ports have either auto-sensing 10/100/1000Base-T RJ-45,
or mini-GBIC connectivity. Dual personality ports use either the 10/100/
1000Base-T RJ-45 connector, or a supported ProCurve mini-GBIC for fiber-
optic connection. If any of the mini-GBIC ports are used the corresponding
RJ-45 port will be disabled. By default, the RJ-45 ports are enabled.
The Series 2510 Switch uses the console port to connect to a PC or workstation
running a VT-100 terminal emulator, or VT-100 terminal. A cable to connect
the console to the switch is supplied.
The Series 2510 Switch does not have a power switch; it is powered on when
connected to an active AC power source. This switch automatically adjusts to
any voltage between 100-127 and 200-240 volts and either 50 or 60 Hz. No
voltage range settings are required.
Power
Fault
Locator
Console
10/100Base-T Ports (1 - 24)  Ports are HP Auto MDI-X
Dual-Personality Ports:
10/100/1000-T (T)
or Mini-GBIC (M)
!
Use only one (T or M)
for each Port
25M
*
Spd mode: off = 10 Mbps, flash = 100 Mbps, on = 1000 Mbps
12
10
8
6
4
2
11
9
7
5
3
1
Link
Mode
Link
Mode
24
22
20
18
16
14
23
21
19
17
15
13
Link
Mode
Link
Mode
Link
Mode
LED
Mode
Clear
Reset
Test
FDx
Spd
Act
*
ProCurve Switch
2510-24
J9019A
26M
25T 26T
Link
Mode
ProCurve Switch 2510-24 (J9019A)
* 10/100/1000Base-T ports have the IEEE Auto MDI/MDI-X feature.
Power, Fault
and Locator
LEDs
Test Status LED
Link and Mode LEDs
Console port
LED Mode select button
and indicator LEDs
Reset and Clear
buttons
Dual-personality ports
(10/100/1000Base-T* or
mini-GBIC)
10/100Base-TX
RJ-45 ports*