HP (Hewlett-Packard) 2824 Switch User Manual


 
Port Status and Basic Configuration
Overview
Overview
This chapter describes how to view the current port configuration and how
to configure ports to non-default settings, including
Enable/Disable
Mode (speed and duplex)
Flow Control
Broadcast Limit
Auto-MDIX
Jumbo Packets on the Series 2800 Switches
QoS Pass-Through Mode for Series 2800 Switches
Configuring Port-Based Priority for Incoming Packets on the 4100gl and
6108 Switches
Using Friendly (Optional) Port Names
Viewing Port Status and Configuring Port
Parameters
Port Status and Configuration Features
Feature Default Menu CLI Web
viewing port status n/a page 10-6 page 10-7 page 10-17
configuring ports See Table 10-1 page 10-7 page 10-10 page 10-17
on pages 10-4
and 10-5.
Note On Connecting If the switch either fails to show a link between an installed transceiver and
Transceivers to
another device, or demonstrates errors or other unexpected behavior on the
Fixed-Configuration
link, check the port configuration on both devices for a speed and/or duplex
Devices
(mode) mismatch. To check the mode setting for a port on the switch, use
either the Port Status screen in the menu interface (page 10-6) or show
interfaces brief in the CLI (page 10-7).
10-3