Filter
Top Products
SMA Configuration Guidelines
26 Using Storage Area Manager on the Storage Management Appliance Application Notes
Storage Area Manager can be successfully installed on the SMA in a dual-redundant
environment. However, the Storage Area Manager discovery process might show
dual-redundant configurations as two separate SANs, even though there is only one. In this
event, Storage Area Manager incorrectly displays duplicate SAN maps with discovered
devices in one SAN, but not the other. If necessary, you can resolve the error using the
following procedure:
1. Delete the devices listed in the Unknown Devices tree in the second SAN map displayed
by Storage Area Manager.
2. Run another discovery operation.
After performing the second discovery, Storage Area Manager will correctly display a
single SAN.
Using Modular Data Routers with the SMA
If you have Modular Data Routers (MDRs) in your SAN, you need to install the Modular Data
Router DPI to communicate with Storage Area Manager. You also need to install the HP
StorageWorks Command Console for Tape Controller Management Element Manager on the
Storage Area Manager server. However, Tape Controller Management (TCM) is not
compatible with other software on the Storage Management Appliance and should not be
installed on the SMA. Instead, it must be installed on some other Windows 2000 or
Windows NT system. This Windows system does not need to be in the SAN, but needs to have
IP connectivity to the SMA and MDRs in the SAN.
After installing the TCM Element Manager on the Windows host, use the Storage Area
Manager application link feature (Tools > Storage Node Manager > Edit Application Link)
to change the URL that launches TCM.
Refer to the HP StorageWorks Modular Data Router Device Plug-In Installation Instructions
and the release notes included with the Modular Data Router DPI for complete details.
To enable the MDR page to launch from Storage Area Manager after you install TCM on the
Windows host, you must allow anonymous access to unsecured pages in the System
Management Home Page. Use the following procedure:
1. Log on using the administrator account on the System Management Home Page
(http://ip_addr:2301/), where ip_addr is the IP address of the Windows system where
TCM is installed. The default password is administrator.
2. Click the Options link. (On some versions of the System Management Home Page, click
the Settings tab and then click Options.)
3. Select Anonymous Access and save the settings.
The Modular Data Router DPI and supporting documentation are available at
http://www.openview.hp.com/products/dpi/in dex.html
.