Filter
Top Products
120
Enhancements
Release M.10.39 Enhancements
You can see if informs are enabled or disabled with the show snmp-server command as shown in Figure
11.
Figure 11. Example Showing SNMP Informs Option Enabled
Release M.10.39 Enhancements
Release M.10.39 includes the following enhancement:
Select whether SNMP traps or informs are sent to this management station.
For more information on SNMP informs, see “Enabling and Configuring
SNMP Informs” on page 119.
[version <1 | 2c | 3>]
Select the version of SNMP being used.
Note: SNMP informs are supported on version 2c or 3 only.
[<none | all | non-info | critical | debug>]
Options for sending switch Event Log messages to a trap receiver. The levels
specified with these options apply only to Event Log messages, and not to
threshold traps.
ProCurve(config)# show snmp-server
SNMP Communities
Community Name MIB View Write Access
---------------- -------- ------------
public Manager Unrestricted
Trap Receivers
Link-Change Traps Enabled on Ports [All] : All
Send Authentication Traps [No] : No
Informs [Yes] : Yes
Address | Community Events Sent in Trap
---------------------- ---------------- -----------------
--
Excluded MIBs
Snmp Response Pdu Source-IP Information
Selection Policy : Default rfc1517
Trap Pdu Source-IP Information
Selection Policy : Default rfc1517