Filter
Top Products
74
Enhancements
Release M.10.04 Enhancements
Examples
To turn on monitoring and event log messaging with the default medium values:
ProCurve(config)# instrumentation monitor
To turn off monitoring of the system delay parameter:
ProCurve(config)# no instrumentation monitor system-delay
To adjust the alert threshold for the MAC address count to the low value:
ProCurve(config)# instrumentation monitor mac-address-count low
To adjust the alert threshold for the MAC address count to a specific value:
ProCurve(config)# instrumentation monitor mac-address-count 767
To enable monitoring of learn discards with the default medium threshold value:
ProCurve(config)# instrumentation monitor learn-discards
To disable monitoring of learn discards:
ProCurve(config)# no instrumentation monitor learn-discards
To enable or disable SNMP trap generation:
ProCurve(config)# [no] instrumentation monitor trap
Viewing the Current Instrumentation Monitor Configuration
The show instrumentation monitor configuration command displays the configured thresholds for
monitored parameters, as shown in Figure 18 on the next page.
An alternate method of determining the current Instrumentation Monitor configuration is to use the
show run command. However, the show run command output does not display the threshold values
for each limit setting.